1988 BMW M3 E30 Base Coupe for Sale

Build: The block is from a '98 M3 and has about 83k miles on the bottom end, the head is off of a '95 m3 and has about 4k miles on it since rebuild.

The 5 speed transmission is from an '02 z3 M off of a s54, one of the strongest 5 speed from BMW. I can't stress how much I love this transmission's gearing, and the shift feedback is the best of

any car I've driven. The differential is a 2.79LSD. The clutch style LSD is super tight and locks up exactly as it should. Car has an unkown brand lightweight flywheel. Thanks to the combination of the z3 M transmission and the 2.79 diff, it gets off the line very quickly but still cruises at highway speed at an acceptable RPM.

The car is currently running a miller W. A. R. chip ECU and can be easily hooked up to a computer and dyno tuned to get the most out of any engine setup you desire. The car also has (unknown brand) shorty headers, Castro Motorsport air box (cruise control motor was removed for the installation of the air box by the previous owner), racing dynamic adjustable sway

bars, bilstein HD struts, and HR sport springs. The wheels are 16" Epsilon Mesh, a BMW dealer option from the 635csi and are one of my favorite parts of the car.

Recent Repairs/ Upgrades: The entire fuel system has been replaced as I found rust starting to form in the original gas tank and didn't want to take any chances. Included in the replacement, new BMW filler neck coupler, rebuilt and flow matched Ca Tuned injectors, new OEM e30 M3 fuel tank, new BMW fuel lines, new BMW low pressure high volume in tank fuel pump, new TRM external fuel pump, new fuel filter, new fuel pressure regulator, and new fuel rail. Other maintenance performed includes, ARP head studs, replacement of all

4 wheel bearings in the last 4 years, as well as brake pads and rotors.

Motor mounts are from a BMW E46. New turner motorsport front swaybar endlinks, new braided brake lines from blunt tech, new wind shield, evo trunk seal, new camber plates from ground control, tie rods replaced two years ago, M5 guibo replaced two years ago, new turner motorsport SI board, new bluetooth alpine head unit, new oil separator, new heater core, new thermostat, new BMW OEM water pump, 6 month old front tires, 18 month old rear tires. New crack free dash. New LED OBC lightbar. Planned future work: Most obvious is that the car needs new paint, as the clear coat is in poor condition.

The original color is Lachs Silber and the previous owner painted the car Sterling but the engine bay and trunk are still Lachs Silber, returning to the original color was my eventual plan. I was also planning on replacing the front bumper prior to paint, as it was reattached poorly by the previous owner and has a small crack (pictured). The body is rust free with the exception of a small spot under the wind shield on the passenger side (pictured) that will need to be treated in the future, but no rust/rot was found hiding under the original windshield when replaced. There are two small dents that can probably be removed through paintless dent removal (also pictured).

The rear subframe bushings and rear trailing arm bushings are original, and replacements are included in the sale. My next project on the M3 was to recondition the air conditioning in the car but I still needed to source a e36 compressor and an e30 evaporator. As well as have the two custom lines made to complete the system. I bought the car with a custom multi-amp stereo system in the trunk that works well, though it never has been a priority for me on this car. It's up to the next owner's discretion whether to keep or remove it.

The driver's seat is in great condition and the passenger seat is in good shape other than some material cracking on the upper shoulder bolster. The rear seat is in acceptable shape for its age but I had planned on eventually recovering it. The A-pillar trim needs to be replaced or recovered as the sun as caused the vinyl to shrink and separate from the plastic. The car is currently driving around on the factory '88 M3 catalytic converter and muffler. It hasn't shown any signs of needing a new cat but the muffler is starting to crack around the welds. Extra Parts I have boxes full of extra mechanical parts for this car that are included in the sale.

Red Label 413 DME, factory s50 exhaust manifolds, new rear subframe bushings, new rear trailing arm bushings, and A/C components.

Used 1988 BMW M3 93,400 miles